| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| .020 fretting blade http://www-.luthiersforum.com/forum/viewtopic.php?f=10101&t=41078 |
Page 1 of 1 |
| Author: | ernie [ Wed Aug 07, 2013 10:28 am ] |
| Post subject: | .020 fretting blade |
I have a .020 fretting blade for my TS it is 5in czech made jewellers blade with a 5/8in arbour . I bought it a while ago and don/t remember where it was purchased . It now cuts a slightly wider ..012 on one end of the cut and slightly deeper abt .020 . Any suggestions for a good narrow fret slotting blade ? I use it with mando wire for ukes Thanks. |
|
| Author: | Phil Marcus [ Wed Aug 07, 2013 3:44 pm ] |
| Post subject: | Re: .020 fretting blade |
What you are describing sounds like either a table saw that requires alignment or a blade that needs sharpening. Tell us more about the blade; is it carbide tipped or steel? |
|
| Author: | ernie [ Wed Aug 07, 2013 6:57 pm ] |
| Post subject: | Re: .020 fretting blade |
TS is fine, the blade is a cheap czech steel 300 tooth jewellers blade which is kaput,it has vy tiny teeth compared to a conventional fret slotting blade.I looked at matco blades, but they don/t have a 5/8in arbor |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|